AM_Vibro-PB.F: Anti-vibration braces for floating drywall systems with Regufoam®

The wall supports are used as anti-vibration braces for floating drywall. The use of these anti-vibration supports is recommended for walls with a fairly high height. This application increases the dynamic stiffness of the wall, as well as the seismic protection of the structure.

General Details:

DESCRIPTION

The Vibro-PBF wall supports are used as anti-vibration braces for floating drywall construction systems, when these walls are anti-vibration installed on a floating floor. The use of these anti-vibration supports is recommended for walls with a fairly high height. This application increases the dynamic stiffness of the wall, as well as the seismic protection of the structure.

The use of this bracket prevents the creation of  sound bridge between two walls and by this way the sound insulation of the structural noise is achieved.

Its clever construction with the insertion of an intermediate metal element, allows the restraint of both compression and tensile forces. Fastening it to the vertical stud of gypsum board  does not require the use of a passing screw, it is enough to use common self-tapping screws that connect it to the metal stud.

The intermediate anti-vibration element is made of semi-enclosed polyurethane foam (Regufoam)produced in Germany by BSW REGUPOL company.

At its base is equipped with oval holes to facilitate installation.


Load Range:


Some applications of Vibro-PB.F can be shown below:



Data Sheet:

AM_Vibro-PB.F.pdf (404kb)