AM_Vibro-EP: Floating Floor Supports

Antivibration supports for: Air-compressors, air conditioning units, pumps, fans, generator sets, cutting machine and more. Vibro-EP is the result of specialised research and is produced in this form since 1989, made from elastomeric material mixed with special substances for its further improvement. Its longitudinal holes increase the provided compression and improve vibration absorption.

General Details:

An anti-vibration rubber vibration isolators, suitable for:

  • Passive machinery protection
  • Suitable for large loads
  • Antivibration supports: Air-compressors – Air conditioning units – Pumps – Fans – Generator sets – Cutting machines etc.
  • Floating support: Industrial floors – Elevators – Printing machines – Testing machines etc.

– 50 x 25 x 2,5 cm – 12,5 x 12,5 x 2,5 cm

– Elastomeric special rubber compound: (grey – blue – red)
– Neoprene: (beige – green – yellow)

Multiple VIBRO-EP rubber vibration isolation pads can be used in layers to form the Vibro-EP Complex. Then with the use of steel plate in between we can achieve a reduction of the natural frequency down to 4 Hz.
A specially formed galvanised metal cover can be used along with the VIBRO-EP to form the Vibro-EP Metal. The steel cover protects the rubber part of the mount from UV radiation and oil and at the same time, the load is applied on the mount equally distributes to the entire surface of the rubber element.

Due to its high abrasion coefficient, Vibro-EP does normally not require to be fixed using screws, glue or plugs.
It can be placed under machinery, metal supports of machinery or under concrete floating inertia supports, in single or multiple layers.

Load Range:

Grey or Beige12.5 x 12.5 x 2.53001.5 – 1.9
50 x 25 x 2.530001.6 – 2.4
Blue or Green12.5 x 12.5 x 2.52000.9 – 1.3
50 x 25 x 2.520001.1 – 1.6
Red or Yellow12.5 x 12.5 x 2.51000.4 – 0.6
50 x 25 x 2.510000.6 – 0.8
Special Rubber CompoundGrey/Blue/Red

Floating Floors:

MEP Application:

Due to its high abrasion coefficient, Vibro-EP does not normally require to be fixed using screws, glue or plugs, except in special cases.
It can be placed under the metal supports of machinery or under concrete floating inertia supports, in single or multiple layers.

Some applications of Vibro-EP can be shown below:

Data Sheet:

AM_Vibro – Dynamic Characteristics Grey.pdf (141kb)

AM-Vibro – Dynamic Characteristics Blue.pdf (141kb)

AM-Vibro – Products Data Sheet.pdf (802KB)